Description
Designed for this exact vehicle and built in our Bayswater workshop, where we’ve been making roll cages since 1978.
About this cage
A 4-point (Type 2) half cage. The rear harness bar takes eye-bolt mounts for up to 4 shoulder straps, and the rear brace diagonal runs between the backstays rather than across the main hoop, so your seat keeps its full range of movement. It is still Motorsport Australia approved. Suits club-level events, drifting and drag racing. Suits sunroof models, and fits with the hood lining and door trims in place.
Our own cage joiner
Every 6-point cage uses our dismountable joiner (SDJ01/11). It’s independently load-tested and stronger than the tube itself, and there are no bolt heads outside the tube, so the finished cage looks welded in.
Paperwork done for you
We complete the Motorsport Australia safety cage registration. Just send us your VIN or chassis number after you order.
Don’t forget padding
Motorsport Australia requires padding wherever your helmet could touch the cage (SFI 45.1 for national level and below). You can add it in the builder above.
